Yo, my name is Dan and I’m here to tell you about the sickest way to smoke your weed – with a waterfall bong. This shiz is innovative and dope, plus it’s hella cheap and easy to create. You can even use stuff you have lying around your crib. Keep reading to learn how to make your own waterfall bong and get lit AF.
So, you might be thinking – isn’t a waterfall bong the same as a gravity bong? Nah, bro. It’s similar, but not the same. Both use air pressure to draw smoke into the bong, but with a gravity bong, you pull it out of the water to create a vacuum. With a waterfall bong, the air pressure changes when the water flows out of a hole in the bottle.
Here’s what you need to make your own:
– An empty plastic bottle with a plastic top (go for a one or two-liter soda bottle, but any size will do)
– A lighter
– Water
– A sharp knife or drill
– Something to catch the water (like a container or sink)
– Weed
– Duct tape
– Slider bowl attachment from a bong (optional)
– Tinfoil (optional)
– Cork (optional)
– Silicone or rubber washer (optional)
Step 1:
Use a knife or drill to make a hole near the bottom of the bottle. A quarter inch is usually good for optimal airflow. Cover it with duct tape once you’re done.
Step 2:
Cover the top of the bottle with a slider bowl to make an airtight seal. If it doesn’t fit, drill a hole in the cap of the soda bottle instead. Heat up the plastic around the hole in the cap for a better seal. Use silicone or rubber washer if needed.
Step 3:
Pack your bowl with weed before adding water to the bottle. This way, your weed won’t get wet and you can easily seal the hole with your fingers. Fill the bottle with water, but leave some room at the top.
Step 4:
Light the weed in the bowl, then open the tape and let the water flow out of the hole. The smoke from the weed will flow into the bottle, creating a milky white smoke inside.
Step 5:
When all the water has drained out, unscrew the top and take a hit! Make sure to do this over a sink or container in case you make a mess.
Boom, now you have yourself a dope waterfall bong. It’s easy to make, but be careful not to spill or break anything. Some people claim that they get super high from this method, so take it easy if you’re a beginner. You can also customize it by using different materials if you don’t have a bowl or cap that fits. For example, use tinfoil or a cork instead.
To make sure you get the best hit possible, here are some tips:
– Check the water level – it shouldn’t be too high or too low
– Use cold water for optimal hits
– Don’t inhale the water – that shiz is gross
Alright, that’s all for now. Go make yourself a waterfall bong and get lit!